Pay in 4 interest-free payments of $30.00 Learn more
Ships within 48 hours · Estimated delivery Aug 6 - Aug 11
QU20461 Outer Axle Shaft uses a 1480 series u-joint will NOT fit the inner shafts that are used with the bigger 1550 u-joint
Tech Note 2: Outer Seal
the modest sized
If the plate is damaged
QU40598 1-1/4" Wide Stepped Hub Drive Gear 1966-1975-ihc-dana-70-rear-axles QU20461 Outer Axle Shaft usesQU40598 1 1 4" Wide Stepped Gear for Dana 30, Dana 44, and GM 10 Bolt Front Axles. QU40598 was the original design. Outside spline that engages wheel hub is 27 32" wide. These gears are stepped on the outboard side to aid in removal and to space the gear back from the hub cap. QU40598 gears were usually used with QU40050 Spring and QU40035 Spring Plate. The back edge of the snap ring groove is approximately 5 16" from the end. Obsolete part, available
US$ 19500.00
US$ 19500.00
US$ 19500.00
US$ 95.99
US$ 19500.00
US$ 19500.00
US$ 114.99
US$ 19500.00
US$ 71.99
US$ 19500.00
US$ 19500.00
US$ 78.99
US$ 34.99